Hello Robert,
On Thu Sep 07 2017 00:02:12, Robert Wolfe wrote to All:
The problem I have is that when passing the com port to Max/2 in EXEBBS.CMD, Max returns with a message say that it cannot load the
comm driver. When I pass al lthe contents of the % variables to a log file, I get the following:
{0}[c:\ftn\fd] type fd.out
Speed: 57600
Port: 1
Event Time: 10080
Task #: 1
Connection Msg: /ARQ/TEL_FROM_127.0.0.1
CID: N/A
Port Handle: 12
I pass the port number as well as the speed and handles to Maximus/2
but it still doesn't accept the connection and I get the following
error message is the logs for this particular node:
{0}[c:\ftn\fd] type \max\Max.Log
+ 06 Sep 23:51:53 MAX Begin, v3.01 (task=1)
! 06 Sep 23:51:53 MAX SYS0032: Cannot open com port (com1)
! 06 Sep 23:51:53 MAX Communications driver not properly installed
However, whenever I run Maximus/2 in WFC mode, I do not get the above error message.
So let me get this straight.
In the first instance, FrontDoor is loading Maximus/2? And in the second instance you're just running Maximus/2? normally?
The only issue I can see is that it states "Communications driver not properly installed", so is there a difference in the way you're executing Maximus/2 from
the command line versus executing it from FrontDoor? Should you be adding something (ie: in a batch file) that pre-loads your fossil driver before passing off to Maximus/2 from FrontDoor?
Regards,
Nick
... "Не знаю. Я здесь только работаю."
--- GoldED+/LNX 1.1.5-b20170303
* Origin: thePharcyde_ distribution system (Wisconsin) (1:154/10)